Page 36 Operating Instructions
Figure 29: Cross conveyor storage stands
How to Operate the Hydraulic Power
Pack
WARNING: Keep clear of all moving
parts.
1. Engage the tow vehicle’s PTO. Do not exceed the
maximum speed of 540 rpm.
2. Test the MH-400 by operating a control valve, such
as the lift cylinders.
3. If the MH-400 is operating properly, engage the
hydraulics by switching on the tow vehicle PTO.
WARNING: Always disengage the PTO
when the MH-400 is not in use.
WARNING: Do not adjust the relief
valve, or your warranty may be voided.
It is set to factory specifications.
Electric Brakes
The Dexter electric brakes and brake drums include a
wiring harness with connectors, a foot controller, and a
load control.
If you purchased the electric brakes, your authorized
Toro distributor will install them. The electric brakes are
designed to work in synchronization with your tow
vehicle’s brakes. Once the electric brakes are installed, do
not use one set of brakes alone to stop the combined load.
Ensure that you read and follow all the supplied manuals
and instructions.
I
MPORTANT: Do not use the electric brakes on roads.
To Next Page
Loading...
Need help?
General
