EN-12
Maintenance
POTENTIAL HAZARD
• If the extension cord is plugged into
snowthrower and the key is in the handle,
someone could accidentally operate
snowthrower while you are performing
maintenance on it.
WHAT CAN HAPPEN
• Operation of snowthrower while
maintenance is being performed on it could
cause serious personal injury
.
HOW TO AV
OID THE HAZARD
• Disconnect extension cord before you do
any maintenance. Hold key down, turn
clockwise and remove key from handle.
Lubricating
Snowthrower
The snowthrower does not have to be lubricated; all
bearings are lubricated for the life of the product at
the factory.
Replacing
Scraper
A replaceable scraper is located at the bottom of the
rotor housing.
1. Remove (2) screws securing scraper to
snowthrower (Fig. 11).
2. Install new scraper and fasten securely with (2)
screws.
1517
1
2
2
Figure 1
1
1. Scraper 2. Screw
Replacing
Rotor
Note: Determine left and right sides of
snowthrower by standing in the normal
operating position.
1. Remove (3) screws securing right side cover and
skid to snowthrower frame (Fig. 12).
1537
1
3
2
Figure 12
1. Right
side cover
2. Screw
3. Skid
To Next Page
Loading...
Need help?
General
