Toro Z Master 74915 - Adjusting the Anti-Scalp Rollers

AdjustingtheHeight-of-CutPin
Theheight-of-cutisadjustedfrom1to5-1/2inches
(25to140mm)in1/4inch(6mm)incrementsby
relocatingtheclevispinintodifferentholelocations.
1.Movethetransportlocktothelockposition.
2.Pushonthedeckliftpedalwithyourfootandraise
themowerdecktothetransportposition(also
the5-1/2inch(140mm)cuttingheightposition)
(
Figure27).
3.Toadjust,rotatethepin90degreesandremovethe
pinfromtheheight-of-cutbracket(Figure27).
4.Selectaholeintheheight-of-cutbracket
correspondingtotheheight-of-cutdesiredand,
insertthepin(
Figure27).
5.Pushonthedecklift,pullbackonthetransport
lock,andslowlylowerthemowerdeck.
Figure27
1.Deckliftpedal
3.Transportlock
2.Cutofheightpin
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itis
recommendedtoadjusttheheightoftheanti-scalp
rollers.
1.Disengagethebladecontrolswitch(PTO),move
themotioncontrolleverstotheneutrallocked
positionandsettheparkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
Figure28
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
Figure29
1.Anti-scalproller3.FlangeNut
2.Bushing4.Bolt
Figure30
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
24