26
Operating manual Cruise 2.0
Contact Torqeedo Services
(for contact details,
see back cover)
yes
Unblock propeller
no
Put tiller into stop position. After
waiting for approx. 2 seconds,
re-start from the stop position
Plug in on/off pin and/or
steering cable.
Correct polarity of the battery
connections.
If necessary, change fuse.
Connect the batteries according
to the connection plan (section
8.3
to 8.5). If necessary, clean the
contacts and treat them with
contact spray. Tighten the contacts.
Charge the batteries according to
the manufacturer‘s instructions.
Is the propeller unobstructed? Can
the propeller be moved by hand?
Is the battery sufficiently charged?
Battery voltage > 20 V ?
(If using 2 serially configured
12 V lead batteries,
10 V per battery?)
Are the batteries correctly
connected? Are the contacts free
of corrosion and tightly fixed?
Is the polarity of the battery
connections correct
(positive terminal on positive pole,
negative terminal on negative
pole)? Is the cable set fuse intact
(no traces of smoldering on the
viewing window)?
Are the on/off pin and the
steering cable connected?
Motor not running?
yes
yes
yes
yes
no
no
no
no
12. Trouble shooting
To Next Page
Loading...
Need help?
General
