22
5.6 Error messages/trouble shooting
Stator over-temperature
(motor overheating)
Motor can be used again after a short wait about 10 minutes).
Contact Torqeedo Service.
Disconnect motor cable from battery, then loosen blockage and
turn propeller one revolution by
hand. Reconnect motor cable.
Voltage in the motor too low
Low battery charging status. Motor can potentially be used again
slowly from the stop position.
Circuit board overheating
Motor can be used again after a short wait about 10 minutes).
Contact Torqeedo Service.
Tiller calibration defective
• Re-calibrate: Press “cal” button for
10 seconds.
• The display shows “cal up”: Press
tiller forward to full gas
then press the “cal”
button.
• The display shows “cal stp”: Return
tiller to central position then
press the “cal” button.
• The display shows “cal dn”: Press
tiller backward to full gas
then press the “cal”
button.
Magnetic sensor defective
Re-calibrate (refer to E21)
Re-calibrate (refer to E21)
Motor communication error
Check the motor cable’s plug-in
connection. Check the motor cable for
damage.
Tiller communication error
Check the tiller‘s plug-in connections. Check the cable.
General communication error
Check the plug-in connections and cables. Switch the motor off and
on again.
Incorrect charging voltage
Use a Torqeedo power supply. If the error occurs in spite of using a
Torqeedo power supply, wait untill the battery dissipates the
overcharge. Should the error persist please contact Torqeedo
Service.
Charge battery. Motor can potentially be used again slowly from the
stop position.
Switch motor off and on again. If this error occurs the battery status
indicator and range display can no longer operate until the battery
has been fully charged again.
To Next Page
Loading...
Need help?
General
