1-12-2 E9TK5FIS
< DVD Section >
Note: If an error occurs, a message with the error number appears on the screen.
Message Solution
Error
No.
Error Description
Can not record on this disc.
Insert the recordable disc, and
ensure the disc status satisfies
the recording requirements.
1 An error occurs during data reading.
2
There is no reply for 15 seconds in Test
Unit Ready.
3
Cannot write the data after trying three
times.
4 An error occurs with OPC.
5 During recovery in a record.
6
An error occurs even if recovery has been
tried three times.
7 An error occurs in a format.
8 It cannot start an encode.
9
NV_PCK/RDI_PCK is not in encoded
data.
10
Encode Pause condition continued for 10
minutes.
11
Encode Pause condition continued in
normal REC condition for 10 minutes.
12
Difference in the address and can not get
Stream ID of RDI/VIDEO.
13 It is a reply that “ATAPI is not readable.”
14
Cannot write the data after recovering
SMALL VMGI.
15
Cannot write the data after DVD-R
Reverse Track.
16 An error occurs in Finalize Close.
17 An error occurs in Rec Stop Close.
18 An error occurs in PCA Full (DVD_R).
19 Safety Stop occurs during editing.
20 High Speed Disc.
21 The disc is not formatted.
22 Disc Error has occurred.
23 The -R Disc of VR Mode.
24
The disc except for finalized DVD-R/RW/
+R/+RW.
This program is not allowed to
be recorded.
You cannot record copy-
prohibited programs.
25 During the Macrovision picture input.
26 During the CGMS picture input.
This program is not recordable
in Video mode.
You cannot record copy-
prohibited programs.
27
During the CGMS picture input. (Video
Format Disc)
Cannot record. Disc not
CPRM comp.
You cannot record copy-
prohibited programs.
28
During the CGMS picture input. (VR
Fomat Disc that is not compatible with
CPRM.)
Recording Error
You cannot record on this disc as
Power Calibration Area is full.
E35
Error No.
Error message
To Next Page
Loading...
Need help?
General
