3.BASIC COPY MODES
Selecting Finishing Mode 97
3 BASIC COPY MODES
5
Select the desired mode from [MAGAZINE SORT], [MAGAZINE SORT & CENTER
FOLD], [MAGAZINE SORT & SADDLE STITCH], [CENTER FOLD] or [SADDLE STITCH].
Then press [OK].
y [MAGAZINE SORT & SADDLE STITCH] and [SADDLE STITCH] are selectable only when the
Saddle Stitch Finisher MJ-1108 or MJ-1037 is installed.
y [MAGAZINE SORT & CENTER FOLD] and [CENTER FOLD] are selectable only when the
Saddle Stitch Finisher MJ-1108 is installed.
6
Select other copy modes as required, and then press the [START] button on the control
panel.
Hole punch mode
You can punch copied paper when the Hole Punch Unit is installed on the Finisher.
y Paper whose size is any of A3, A4, A4-R, B4, B5, B5-R, FOLIO, LD, LG, LT, LT-R, ST-R and COMP, and
whose weight is 60 to 256 g/m
2
(16 to 140 lb. Bond) (MJ-6104) or 60 to 128 g/m
2
(16 to 34 lb. Bond)
(MJ-6007 / MJ-6008) is available.
y Special paper such as OHP film or sticker labels is not applicable.
1
Place paper in the drawer(s).
When using bypass copying, be sure to set the paper size.
2
Place the original(s).
7
Combine the copied paper if the center fold mode or
magazine sort & center fold mode is used.
In the center fold mode, paper is folded at the center for every 5
sheets before exiting. If more than 5 sheets of paper are copied,
combine them as shown in the figure.
11~15
6~10
1~5
1~56~1011~15
To Next Page
Loading...
Need help?
General
