UNIT OPERATION
TIMER OPERATION
ON Timer
PROCEDURE
ON TIMER button
Press this button.
On start up, time is set at 6:00 A.M..
HOUR, MINUTE buttons
Press these buttons to set the start-up time
desired while the ON Timer symbol is flashing.
RESERV. button
Press this button when pointing the remote control towards
the receiver of the indoor unit.
• A receiving beep is heard.
• TIMER lamp of the indoor unit illuminates.
MODE, FAN, FLAP, and TEMP. buttons
Set the desired operation mode with these buttons.
About ON Timer
• When the ON Timer is set, the unit monitors the room
temperature for 1hour before the set time to make sure
the room condition is reached by the reserve time.
• The actual on time of the unit is earlier that the reserved
time by 0 to 40 minutes according to the difference
between room temp. and set temp.
1
2
3
4
NOTE
• The current time is not indicated during the reservation of ON/OFF Time.
• When you want to know the current time, press the CLOCK button and you will see the current time for 5 seconds.
• If you reserve the ON Timer during operation, the unit will operate continuously
SLEEP
MODE FAN FLAP
CLOCK
EVERYDAY
HOUR MINUTE
RESERV.
RST TA
TIMER
ON OFF
CANCEL
A
A
TEMP.
ON/OFF
OWNER
,
S MANUAL - 15
햳
햴
햵
햲
To Next Page
Loading...
Need help?
General
