Toshiba Tosvert VF-S15 Manual

E6582051
- 7 -
2. Overview
This product is a dual port PROFINET communication module that can be used in a PROFINET Industrial
Ethernet. This product also offers an embedded Web server which offers comfortable monitoring and
setup directly from a standard web browser.
2.1. Specification
Module specifications
Item
Specification
Type-form
PNE001Z
Applicable inverter
VF-S15 CPU1 Ver.112 or later (With SBP009Z)
VF-AS3
Connector
Dual RJ45 shielded connector
Supported network
PROFINET, Modbus TCP
Indicator
4 LEDs indicating the communication status and error
status.
Protection degree
IP20
Environments
Correspond to inverter.
Network specifications
Item
Specification
PROFINET
Baud rate
100Mbps (Full duplex)
Cyclic communication
PROFIdrive V.4.1
(Telegram1)
4PKW and 2 PZD vendor format (Telegram100)
4PKW and 6 PZD vendor format
(Telegram101)
6 PZD vendor format
(Telegram102)
Acyclic communication
Reading the PROFIdrive parameter
Reading/writing the inverter parameters
Configuration
Configure by PROFINET master
IP configuration mode
Manual setup, DCP, DHCP, Embedded Web server
PROFINET IO classes
Conformance Class-B
I&M
I&M function 0
Response time
*Cyclic communication About 11ms on VF-AS3
Cyclic communication About 14ms on VF-S15
Modbus TCP
Baud rate
10/100Mbps (Full/Half duplex)
Supported function
Read Holding Registers (03H)
Write Single Register (06H)
Write Multiple Registers (10H)
Read Device Identification (2BH)
IP configuration mode
Manual setup, DHCP, Embedded Web server
Ethernet
MRP
Supported
LLDP
Supported
Web server
Inverter status monitor, inverter parameter
monitor/configuration, Network status monitor,
password lock
*Response time is the time until the inverter is operated by RUN command on the cyclic communication

Toshiba Tosvert VF-S15 Specifications

General

Brand	Toshiba
Model	Tosvert VF-S15
Category	Inverter
Language	English