Toto WASHLET SW4047AT60 User Manual

36 37
If you cannot operate with the remote control

If the low battery warning mark "
" on
the back of the remote control is fl ashing,
please replace the batteries.
It is the time to replace the batteries.
If the water does not fl ow due to a water service interruption
When the ambient temperature is likely to drop to 32 °F (0 °C) or lower, take measures to prevent freezing.
Attention!
•
When the ambient temperature is likely to drop to 32 °F (0 °C) or lower, do not use the energy saver feature. (May damage the product.)
•
Warm the bathroom or take measures against freezing so that the ambient temperature does not drop below 32 °F (0 °C).
•
Before starting to work, set "Auto fl ushing" to "OFF" (Except SW4047T60 and SW4049T60). (Page 32)
How to freeze damage prevention
1
Close the shutoff valve.
(Page 41)
•
The water supply stops.
CAUTION
Do not remove the water fi lter drain
valve while the shutoff valve is open.
(Otherwise, water may leak out.)
2
Press
"Wand CLEAN" button.
(Release the pressure from the water supply
pipe.)
3
Remove the cover on the left
side of the main unit, and fl ip the
power switch to "OFF".
(Page 15)
4
Remove the water fi lter drain
valve.
•
Loosen the water fi lter drain valve with a
fl at-head screwdriver and then pull it.
Water Filter
Drain Valve
Flat-head screwdriver
5
When water draining is
completed, reinstall the water
fi lter drain valve.
•
Insert the water fi lter drain valve and use a
fl at-head screwdriver to tighten it securely.
6
Flip the power switch to ON.
(Page 15)
•
The "Power" LED lights up.
7
Reinstall the cover.
(Page 27)
8
Set the toilet seat temperature
to "High".
(Page 20)
•
To maintain the temperature, close the
toilet seat and toilet lid after fi nishing work.
■
To use the product again
•
The water needs to be resupplied. (Page 39)
What to Do?
If the water does not fl ow due to a water service interruption
If you cannot operate with the remote control
1
Use a bucket to fl ush water.
2
If the water level is low after
fl ushing, add more water.
•
Prevents odors.
Attention!
•
Before starting to work, set "Auto fl ushing" to "OFF" (Except SW4047T60 and SW4049T60). (Page 32)
•
When the water supply is restored, be sure to perform a fl ush. (To prevent waste from remaining in the drain pipe.)
Newspaper, dust cloth, etc.
Large bucket
Pour strongly, aiming
at the center of the
bowl unit.
Freeze Damage Prevention
■
Replacing the batteries
1
Remove the cover on the left
side of the main unit, and fl ip
the power switch to "OFF".
(Page 15)
2
Remove the remote control
from the hanger.
(Page 14)
3
Open the battery cover and
replace the two AA batteries.
(Page 14)
•
The low battery warning mark goes off.
4
Mount the remote control in the
hanger.
Attention!
•
"ON" and "OFF" settings of the functions such as the energy saver function may be canceled when the batteries
are replaced.
Set them again.
5
Flip the power switch to ON.
(Page 15)
•
The "Power" LED lights up.
<Power>
6
Reinstall the cover.
(Page 27)
Reference

Toto WASHLET SW4047AT60 Specifications

General

Brand	Toto
Model	WASHLET SW4047AT60
Category	Bathroom Fixtures
Language	English