171
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
Halogen bulbs have pressurized
gas inside and require special han-
dling. They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case. Do
not touch the glass part of a bulb
with bare hands.
CAUTION
!
NOTICE
Only use a bulb of the listed type.
Light bulbs Bulb
No.
W Type
Headlights HB2 60/55 A
Parking, front side
marker and front turn
signal lights
1157 27/8 B
Rear side marker lights 168 5 C
Rear turn signal lights 1156 27 B
Stop and tail lights 1157 27/8 B
Back-up lights 1156 27 B
License plate lights - 5 C
High mounted
stop light 921 18 C
Interior light - 8 D
Trunk light 194 3.8 C
A: HB2 halogen bulbs
B: Single end bulbs
C: Wedge base bulbs
D: Double end bulbs
1. Open the hood. Unplug the con-
nector. Remove the rubber cover.
If the connector is tight, wiggle it.
Replacing light bulbs— —Headlights
To Next Page
Loading...
Need help?
General
