EasyManuals Logo

Toyota 2003 4Runner User Manual

Toyota 2003 4Runner
730 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #286 background imageLoading...
Page #286 background image
’03 4Runner_U (L/O 0211)
150
2003 4RUNNER from Oct. ’02 Prod. (OM35804U)
The light may come on for 60 seconds
after the ignition key is turned to “ON”. It
is normal if they go out after a while.
Depressing the brake pedal repeatedly
may turn on the light. It is normal if they
go out after a few seconds.
If the light comes on while driving, the
vehicle skid control system does not work.
However, as normal braking operates
when being applied, there is no problem
to continue your driving.
In the following cases, contact your Toyota
dealer:
The warning light does not come on
after the ignition key is turned to “ON”.
The warning light remains on after the
ignition key is turned to “ON”.
The warning light comes on while driv-
ing.
The downhill assist control system is a
system that assists the deceleration of
the engine brake when you drive down
a steep hill. When you are driving down
a hill with the four–wheel drive control
switch knob (full–time four–wheel drive
models) or multi–mode control switch
knob (multi–mode four–wheel drive
models) in the “L4” position, push the
“DAC” switch to limit the vehicle’s ac-
celeration. If the vehicle is traveling at
a speed of 25 km/h (15 mph) or less,
you can descend at a constant speed.
CAUTION
Do not rely excessively on the down-
hill assist control system. It may not
be able to maintain a low speed over
road surfaces or off–road surfaces on
which sliding can easily occur, such
as extremely steep slopes or icy or
muddy roads.
TO ACTIVATE THE DOWNHILL ASSIST
CONTROL SYSTEM
1. Full–time four–wheel drive models—
Turn the four–wheel drive control
switch knob to the “L4” position.
The system will not operate if the four–
wheel drive control switch knob is in the
“H4” position.
Multi–mode four–wheel drive mod-
els—Turn the multi–mode control
switch knob to the “L4” position.
The system will not operate if the multi–
mode control switch knob is in the “H4
position.
2. In order to make full use of the en-
gine brake, putting the transmission
in “L” or “2” is recommended.
5–speed automatic transmission—The sys-
tem will operate even if the transmission
selector lever is in “D”, “4”, “3” or “N”.
However, when it is in “L” or “2” the en-
gine brake can also be utilized enabling
the system to operate more effectively.
4–speed automatic transmission—The sys-
tem will operate even if the transmission
selector lever is in “D”, “3” or “N”. Howev-
er, when it is in “L” or “2” the engine
brake can also be utilized enabling the
system to operate more effectively.
Downhill assist control system
(four–wheel drive models)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toyota 2003 4Runner and is the answer not in the manual?

Toyota 2003 4Runner Specifications

General IconGeneral
BrandToyota
Model2003 4Runner
CategoryAutomobile
LanguageEnglish

Related product manuals