EasyManuals Logo

Toyota 2003 4Runner User Manual

Toyota 2003 4Runner
730 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #320 background imageLoading...
Page #320 background image
’03 4Runner_U (L/O 0208)
144
2003 4RUNNER from Aug. ’02 Prod. (OM35795U)
At this time, the “VSC TRAC” warning
light will come on and the downhill assist
control system stops operating temporarily
in order to protect the brake actuator. (Al-
though the downhill assist control system
does not operate, it is no problem to con-
tinue your driving.) The system will be
automatically restored after a short time
and the “VSC TRACwarning light goes
out.
If the warning light comes on while driv-
ing, the system does not work. However,
as normal braking operates when being
applied, it is no problem to continue your
driving.
In the following cases, contact your Toyota
dealer:
The warning light does not come on
after the ignition key is turned to “ON”.
The warning light remains on after the
ignition key is turned to “ON”.
The warning light comes on while driv-
ing.
The hill–start assist control system as-
sists you in starting to move up a
steep or slippery hill. When you start
to move up the hill slope, the system
helps to prevent the vehicle from roll-
ing backward in the interval while you
move your foot from the brake pedal to
the accelerator pedal.
CAUTION
Do not rely excessively on the hill–
start assist control system. The ve-
hicle may not be able to start
smoothly on road surfaces or off–
road surfaces such as extremely
steep slopes or icy roads, on which
sliding can occur very easily.
Do not use the hill–start assist con-
trol system to stop the vehicle. This
system is not designed as a func-
tion for stopping the vehicle on a
uphill slope.
The hill–start assist control system will
operate for 5 seconds maximally when
all of the following conditions apply.
When the transmission is in any of
positions “D”, “4”, “3”, “2” or “L”
When the brake pedal is not de-
pressed
The system is designed to operate when
the vehicle is starting on an uphill slope;
therefore, if the transmission is in “P” or
“N” it will not operate. It will not operate
either if the vehicle starts to move in
reverse on a slope with the transmission
in the “R”.
Hill–start assist control
system

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toyota 2003 4Runner and is the answer not in the manual?

Toyota 2003 4Runner Specifications

General IconGeneral
BrandToyota
Model2003 4Runner
CategoryAutomobile
LanguageEnglish

Related product manuals