Toyota 2005 Matrix User Manual

’05 MATRIX_U (L/O 0409)
272
2005 MATRIX from Sep. ’04 Prod. (OM12892U)
Low level Full level
Add oil O.K. Too full
1ZZ−FE engine
Low level Full level
Add oil O.K. Too full
2ZZ−GE engine
With the engine at operating tempera-
ture and turned off, check the oil level
on the dipstick.
1. To get a correct reading, the vehicle
should be on level ground. After turning
off the engine, wait a few minutes for
the oil to drain back into the bottom of
the engine.
2. Pull the dipstick out, hold a rag under
the end and wipe it clean.
3. Reinsert the dipstick—push it in as far
as it will go, or the reading will not be
correct.
4. Pull the dipstick out and look at the oil
level while holding a rag under the
end.
NOTICE
Be careful not to drop engine oil on
the vehicle components.
If the oil level is below or only slightly
above the low level, add engine oil of
the same type as already in the engine.
Remove the oil filler cap and add engine
oil in small quantities at a time, checking
the dipstick. We recommend that you use
a funnel when adding oil.
The approximate quantity of oil needed to
raise the level between low and full on the
dipstick is indicated below for reference.
When the level reaches within the correct
range, install the filler cap hand−tight.
Oil quantity, L (qt., lmp. qt.):
1ZZ−FE engine 1.3 (1.4, 1.1)
2ZZ−GE engine 1.5 (1.6, 1.3)
NOTICE
! Be careful not to spill engine oil on
the vehicle components.
! Avoid overfilling, or the engine
could be damaged.
! Check the oil level on the dipstick
once again after adding the oil.
Checking the engine oil level

Toyota 2005 Matrix Specifications

General

Brand	Toyota
Model	2005 Matrix
Category	Automobile
Language	English