Toyota 2007 Matrix User Manual

22
 Mode 4—Automatic locking and un-
locking linked with the shift position
and ignition switch
Locking function—All the side doors
and back door are automatically locked
when the selector lever is moved out
of the “P” position with the ignition
switch in the “ON” position and all the
doors are closed.
Unlocking function—All the side doors
and back door are automatically un-
locked when the ignition switch is
turned from the “ON” position to the
“ACC” or “LOCK” position.
CHANGING THE MODE
The mode toggles through from mode
1 to mode 4. To change the mode, do
the following:
1. Set the interior light switch to the
“DOOR” position. (See “Interior lights”
on page 95 in Section 1−5.)
2. Shift the selector lever into the “P”
position and close all the side doors
and back door.
3. Turn the ignition switch to the “ON”
position.
4. Within 5 seconds after the ignition
switch is turned to the “ON” position,
push and hold the power door lock
switch on the front side for about 5
seconds.
5. The interior light will flash to indicate
that the mode has been changed.
The flashing of the interior light indicates
the mode which has been selected.
 Flashing once, the function has
changed to mode 1.
 Flashing twice, the function has
changed to mode 2.
 Flashing three times, the function has
changed to mode 3.
 Flashing four times, the function has
changed to mode 4.
If the battery is disconnected or run down,
the mode may change. Set the desired
mode by following the above procedures.
Window lock
switch
Driver’s door
Front
Rear
Passengers’ doors
Power windows

Toyota 2007 Matrix Specifications

General

Brand	Toyota
Model	2007 Matrix
Category	Automobile
Language	English