Power
windows
The
windows
can
be
operated
with
the
switch
on
each
side
door.
The power windows work when the ignition
switch is in the "ON" position.
OPERATING
THE
DRIVER'S WINDOW
Use
the
switch
on
the
driver's
door.
Normal
operation:
The window moves as
long as you hold the switch.
To
open: Lightly push down the switch.
To
close: Lightly pull up the switch.
fj}
q12060
Automatic
operation:
Push the switch
completely down or pull it completely up,
and then release it. The window will fully
open or close.
To
stop the window part-
way, lightly move the switch in the oppo-
site direction and then release it.
Key
off
operation:
The
driver's
power
window works for about 43 seconds even
after the ignition switch is turned off. It
stops working when you open either front
door.
Jam
protection
function:
During automat-
ic closing operation or key
off
closing op-
eration, the window will stop and return to
the
half-open
position if something gets
caught between the window ang window
frame. If you pull and hold the switch
completely up, this function does not
work.
If the window receives a strong impact,
this function may work ever]
if
nothing is
caught.
If
the
battery
is
disconnected
or
rl,ln
down,
the power window may not operqte
automatically and the jam protection func-
tion will not function
correctly
after you
reconnect, replace or recharge the battery.
In
any of these cases, you should normal-
ize the power window.
To
normalize the power window:
1.
Push down the power window switch
and lower the window halfway.
2.
Pull up the switch until the window
closes and hold the switch
for
a sec-
ond.
Make sure
that
the window opens and
closes automatically. If the power window
cannot be operated properly, have it
checked by your Toyota dealer.
21
To Next Page
Loading...
Need help?
General
