'-4
INTRODUCTION
- General Repair Instructions
GENERAL
REPAIR
INSTRUCTIONS
1.
Use
fender
seat
and
floor
covers
to
keep the vehicle clean
and prevent damage.
2. During disassembly. keep parts
in
order for reassembly.
3. Before performing electrical
or
fuel work, disconnect
the
negative
(-)
battery
cable.
4.
Check hose and wiring connectors
to
make sure
that
they
are secure and correct.
5. Always replace gaskets and D-rings with new ones.
6. Always use sealer on gaskets
to
prevent leaks.
7. Carefully observe all specifications for
bolt
torques.
Always
use
a torque wrench.
8.
Use
of
Special Service Tools (SST) may be required,
depending on
the
nature
of
the
repair.
Be
sure
to
use
the
SST where specified, and follow
the
proper work proce-
dure.
9_
Care must be
taken
when jacking up and supporting
the
vehicle_
Be
sure
to
lift and
support
the
vehicle at
the
proper locations_
(a
) If
the
vehicle
is
to
be jacked up only
at
the
front
or
rear end, be sure
to
block
the
wheels
in
order
to
ensure safety.
(b)
Always use a hydraulic hoist or jack stand. It is
extremely dangerous
to
work on a veh icle supported
only by a jack, even for a small job
that
can be
finished quickly.
To Next Page
Loading...
Need help?
General
