96
Chapter 15
Customize Your Network Settings
3. Enable Link Aggregation.
Note: Link Aggregation and IPTV/VLAN cannot be enabled at the same time to avoid LAN port conflicts.
4. Select the Static LAG or LACP mode. It’s recommended that you select the same link
aggregation mode for both ends of the link.
5. Click SAVE . The LAN2 and LAN3 ports will be used for Link Aggregation.
15. 4. Configure to Support IPTV Service
I want to:
Configure IPTV setup to enable Internet/IPTV/Phone service provided by my internet
service provider (ISP).
How can I do that?
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to Advanced > Network > IPTV/VLAN.
3. If your ISP provides the networking service based on IGMP technology, e.g., British
Telecom(BT) and Talk Talk in UK:
1 ) Tick the IGMP Proxy and IGMP Snooping checkbox, then select the IGMP Version,
either V2 or V3, as required by your ISP.
2 ) Click SAVE .
To Next Page
Loading...
Need help?
General
