39
General Information
Side Cover (all models except
Scrambler)
1. S i d e c o v e r
2. Fastener
3. Seat removal tool
The right hand side cover can be removed to
gain access to the fuse box, seat removal tool,
rear brake fluid reservoir etc.
To remove the side cover, release the cover's
threaded fastener using a coin.
Lift the cover until it clears its retaining
dowels and then remove the cover from the
motorcycle.
To install, position the cover over its locating
dowels, install the threaded fastener and
tighten with a coin.
Finally, grasp the cover and ensure that it is
fully retained.
Right Hand Side Cover
(Scrambler only)
1. S i d e c o v e r
2. Retaining dowels/grommets
The right hand side cover can be removed to
gain access to the fuse box.
To remove the side cover, pull the top of the
cover away from the motorcycle until it clears
its retaining dowels (leaving the grommets in
place) and then lift up and remove the cover
from the motorcycle.
To install, position the lower locating dowels,
then press firmly to secure the cover into the
upper grommets.
Ensure the cover is correctly located over the
upper and lower locating dowels.
Finally, grasp the cover and ensure that it is
fully retained.
To Next Page
Loading...
Need help?
General
