41
General Information
Remove the fasteners from the rear of the
seat, collecting the stepped sleeves, and lift
the seat clear of the frame.
Seat Care
To prevent damage to the seat or seat cover,
care must be taken not to drop or lean the
seat against any surface which may damage
the seat or seat cover.
To install, locate the seat to the frame
ensuring the locating tongue is correctly
positioned beneath the fuel tank bridge.
Finally, install the stepped sleeves, and
tighten the seat retaining screws.
Store the Allen key in the space provided and
install the right/left hand side cover.
Stand
Side Stand
1. S i d e s t a n d
The motorcycle is equipped with a side stand
on which the motorcycle can be parked.
Whenever the stand is used, before riding,
always ensure that the stand is fully up after
first sitting on the motorcycle.
For instructions on safe parking, refer to the
'How to Ride the Motorcycle' section.
To prevent damage to the seat or seat
cover, care must be taken not to drop the
seat. Do not lean the seat against the
motorcycle or any surface which may
damage the seat or seat cover. Instead,
place the seat, with the seat cover facing
upwards, on a clean, flat surface which is
covered with a soft cloth.
Do not place any item on the seat which
may cause damage or staining to the seat
cover.
The motorcycle is fitted with an interlock
system to prevent it from being ridden
with the side stand in the down position.
Never attempt to ride with the side stand
down or interfere with the interlock
mechanism as this will cause a dangerous
riding condition leading to loss of
motorcycle control and an accident.
To Next Page
Loading...
Need help?
General
