ALUS requires the user to enter 4 parameters as mentioned in the parameter entry
instructions. As a result, ALUS will be the most accurate mode when using stick on
weights. Please refer to the STICKING AND CLAMPING WEIGHT POSITION
INDICATOR on the display screen and the following diagram when placing the weights
on the rim.
The process is the same as the dynamic and static modes. The only difference is the
parameter input and the position where weights will be put.
12. OPT mode
Please refer to the tire manufacture for instructions on how to match tires to the correct
rim.
14. Errors and Trouble shooting
The result of measurement
is beyond the range.
The user did one of the
following: the user
attempted to calibrate the
machine but did not add
wheel weights. The user
placed a wheel that is either
too light or too heavy for
the machine.
Machine gives this prompt
when the STOP button is
pressed while a wheel is
spinning
To Next Page
Loading...
Need help?
General