Triumph Protect+ User Manual

4 of 9
The Remote Control
Note:
• In the interests of security it is not
recommended to attach the Protect+ remote
control to the motorcycle key.
Operation
The Triumph Protect+ is provided with 2 remote
controls as standard.
It is possible to add up to 4 extra remote controls (6
in total).
We recommend making use of both remote controls
from time to time, ideally alternating use every 3 to
6 months.
The left hand ‘Arm/Disarm’ button controls the
main arm/disarm functions of the system.
The right hand ‘Programming’ button is used to
initiate secondary functions such as movement
sensor deactivation (Transport Mode) and bike
finder.
When either button is pressed on the remote
control, the LED indicator will illuminate to confirm
the button has been pressed and the remote
transmitter is operating. If the LED indicator does
not illuminate when either button is pressed replace
the battery as detailed below.
1. Arm/Disarm button
2. Programming button
3. LED indicator
Replacing the Battery
Each remote control contains a single long-life
lithium battery (CR2450).
Please replace the remote battery when the range
of operation decreases noticeably.
1. To replace the battery, locate the recess in the
edge of the remote control casing and gently
prise the upper and lower sections of the
casing apart at this point.
2. The battery is retained by a clip on the remote
control circuit board and can be removed by
sliding the battery out from under the clip in
the direction shown. Fit the new battery,
ensuring the battery polarity is correct, by
sliding the battery under the retaining clip in
the direction shown.
1. Remote control circuit board
2. Retaining clip
3. Battery
3. Align the two casing halves and squeeze firmly
to click the casing back together, ensuring the
joint is even around the perimeter.
2
1
3
Notice
Make sure the used battery is disposed of, or
recycled in accordance with local environmental
regulations. Incorrect disposal or recycling of a
battery may result in prosecution.
Caution
When removing, or fitting a battery in the remote
control make sure it is removed or fitted in the
correct direction. Failure to remove or fit a battery
correctly could result in damage to the remote
control and possible malfunction.
Remove
Fit
2
1
3

Triumph Protect+ Specifications

General

Brand	Triumph
Model	Protect+
Category	Security System
Language	English