Triumph Protect+ User Manual

8 of 9
Troubleshooting
If the Triumph Protect+ does not react to the
remote control when arming or disarming check the
following:
• LED Indicator is illuminating on the remote
when the Arm/Disarm button is pressed. If not
replace the remote control battery.
• Operate the remote directly adjacent to the
motorcycle in case of local radio frequency (RF)
interference.
• If a local source of RF interference is identified,
move the motorcycle away from the area and
attempt to operate the Triumph Protect+ again.
Customising the System
The Triumph Protect+ has been designed to be
simple to operate and to allow certain features to
be programmed to suit personal preference or
requirements. The user programmable options are:
• Arm/Disarm tones – quiet, loud or off (default)
• Automatic Rearming - on or off (default)
• Passive Arming at ignition off – activate at;
30 seconds, 60 seconds, 120 seconds, or off
(default)
• Battery type – lead acid (default) or lithium ion
Note:
• Sensitivity movement can only be adjusted by
a Triumph dealer, due to Thatcham approval
requirement.
Programming Guide
To customise the Triumph Protect+ features to the
user preferred options follow the programming
guides below.
To Adjust the Arm/Disarm Tone
1. Disarm the Triumph Protect+.
2. Turn on the ignition.
3. Within 10 seconds, press and hold both buttons
on the remote control.
4. After 3 seconds the Triumph Protect+ will start
to chirp. Release the remote control buttons
after the first chirp. The Triumph Protect+ will
bleep a specified number of times to indicate
the current setting.
5. Press the Arm/Disarm button on the remote
control to cycle through the tone options:
• Off (1 Bleep).
• Quiet (2 Bleeps).
• Loud (3 Bleeps).
6. Turn off the ignition to exit programming and
save the new setting.
To Adjust The Automatic Rearm
1. Disarm the Triumph Protect+.
2. Turn on the ignition.
3. Within 10 seconds, press and hold both buttons
on the remote control.
4. After 3 seconds the Triumph Protect+ will start
to chirp. Release the remote control buttons
after two chirps. The Triumph Protect+ will
bleep a specified number of times to indicate
the current setting.
5. Press the Arm/Disarm button on the remote
control to cycle through the automatic rearm
options:
• Off (1 Bleep).
• On (2 Bleeps).
6. Turn off the ignition to exit programming and
save the new setting.
Caution
It is important that the internal battery in the
Triumph Protect+ is not left in a discharged
condition.
If the Triumph Protect+ internal battery is left
discharged it will result in damage to the battery.
If the motorcycle is to be left unused for any
period beyond two weeks it should be connected
to an appropriate battery conditioner to maintain
good battery condition.
Battery issues resulting from improper
maintenance are not covered under warranty.

Triumph Protect+ Specifications

General

Brand	Triumph
Model	Protect+
Category	Security System
Language	English