General Information
65
If the smart key battery is discharged,
then use the smart key in the standard
key operation method.
1
1. System sensor location
Standard Key Operation
To turn the motorcycle on with the
standard key (or the smart key if the
battery is discharged):
• Remove the seat.
•
The system sensor
location is shown as a
signal symbol in the
seat storage tray.
• Hold the standard key on the
system sensor located under the
seat.
• The standard key must be held
against the system sensor while
pressing the Engine Start/Stop
switch in either the QUICK START
or Power ON/OFF position (see
page 66).
Master Ignition Switch
(if equipped)
Master Ignition Switch
The master ignition switch is only
mounted to motorcycles in the United
States. The master ignition switch is
located on the left hand side of the
motorcycle.
To operate the motorcycle with the
keyless ignition, the master ignition
switch must be in the ON position.
If the master ignition switch is in the
OFF position then the keyless ignition
cannot be used and the motorcycle can
not be started.
To Next Page
Loading...
Need help?
General
