How to Ride the Motorcycle
96
Stopping the Engine
Fuel
HOLD TO RESET
N
321
1. Neutral indicator
2. Engine stop switch - STOP position
3. Master ignition switch - OFF position
(if equipped)
To stop the engine:
• Close the throttle completely.
• Select neutral.
• Place the engine stop switch in the
STOP position.
• Turn the master ignition switch to
the OFF position (if equipped).
• Select first gear.
• Support the motorcycle on a firm,
level surface with the side or center
stand.
• Lock the steering.
Caution
Do not leave the ignition switched
on with the engine stopped. This will
cause electrical damage.
Starting the Engine
Warning
Never start the engine or run the
engine in a confined area.
Exhaust fumes are poisonous and can
cause loss of consciousness and death
within a short period of time.
Always operate the motorcycle in the
open air or in an area with adequate
ventilation.
Caution
The low oil pressure warning light
should go out shortly after the engine
starts.
If the low oil pressure warning light
stays on after starting the engine,
stop the engine immediately and
investigate the cause.
Running the engine with low oil
pressure will cause severe engine
damage.
Fuel
HOLD TO RESET
N
321
1. Master ignition switch - ON position
(if equipped)
2. Engine stop switch - QUICKSTART position
3. Neutral indicator
To Next Page
Loading...
Need help?
General
