MAINTENANCE
123
The engine oil and engine oil filter must
be replaced in accordance with
scheduled maintenance requirements.
▼ Warm up the engine thoroughly, and
then stop the engine and secure the
motorcycle in an upright position on
level ground.
▼ Remove the wire clip and detach the
TSA shift force sensor from the gear
change knuckle.
1. Wire clip
2. TSA shift force sensor
▼ Loosen the fasteners and remove
the front sprocket outer cover.
1. Sprocket cover
2. Fasteners
▼ Note the orientation of the wire
guide and the routing of the harness
and hoses through the wire guide for
installation.
▼ Detach the side stand switch
connector from the oil filter cover.
▼ Loosen the fastener and remove the
engine oil filter cover and wire guide.
1. Side stand switch connector
2. Fastener
3. Cover
4. Wire guide
5. Engine subharness
6. Fuel tank drain hose
7. Coolant expansion tank drain hose
▼ Place an oil drain pan beneath the
engine.
▼ Remove the oil drain plug and
discard the sealing washer.
1. Oil drain plug
2. Oil filter
To Next Page
Loading...
Need help?
General
