9se c t i O n 3 — as s e M b l y & se t -up
Front Caster Wheels
This chipper shredder vacuum is equipped with front caster
wheels. The casters can be locked in a straight ahead position or
to swivel freely.
Place pins in smaller holes to allow casters to rotate freely 1.
for maneuvering around trees and flower beds. See Fig.
3-8.
Lift and place pins in the larger holes for locked or straight 2.
ahead operation and when operating on slopes.
Set-Up
Gas and Oil Fill-Up
Refer to the separate engine owner’s manual for additional
engine information.
Add oil provided before starting unit for the first time out 1.
of the box.
Service the engine with gasoline as instructed in the 2.
separate engine owner’s manual.
WARNING: Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
WARNING: Never fill fuel tank indoors with engine
running or until the engine has been allowed to cool
for at least two minutes after running.
Adjustments
Nozzle Height
The nozzle adjustment levers are located on each side of the
nozzle door. The nozzle door can be adjusted to one of five
positions, ranging from 1/2” to 3” ground clearance, to provide
best performance.
Push adjustment lever out away from nozzle.1.
Slide the height adjustment lever forward or backward for 2.
adjusting the nozzle door upwards or downwards. See Fig.
3 -7.
Release lever towards nozzle.3.
NOTE: Height must be adjusted equally. In general, raise
the nozzle to vacuum a thick layer of leaves and lower the
nozzle for smooth surfaces.
Figure 3-7
Figure 3-8
To Next Page
Loading...
Need help?
General
