EasyManuals Logo
Home>Troy-Bilt>Chipper>CSV206

Troy-Bilt CSV206 User Manual

Troy-Bilt CSV206
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
SECTION7: TROUBLESHOOTING
Problem Cause Remedy
Engine fails to start
Engine runs erratic
1. Spark plug wire disconnected.
2. Fuel tank empty or stale fuel.
3. Throttle control lever not in correct
starting position. (If Equipped)
4. Choke not in CHOKE position.
(If Equipped)
5. Blocked fuel line.
6. Faulty spark plug.
1. Spark plug wire loose.
2. Unit running on CHOKE.
(If Equipped)
3. Blocked fuel line or stale fuel.
4. Water or dirt in fuel system.
5. Dirty air cleaner.
6. Carburetor out of adjustment.
1. Connect wire to spark plug.
2. Fill tank with clean, fresh gasoline.
3. Move throttle lever to FAST position.
4. Move choke to CHOKE position.
5. Clean fuel line.
6. Clean, adjust gap, or replace.
1. Connect and tighten spark plug wire.
2. Move choke lever to OFF position.
3. Clean fuel line; fill tank with clean, fresh
gasoline
4. Drain fuel tank. Refill with fresh fuel.
5. Clean or replace air cleaner.
6. See authorized service dealer.
Too much vibration 1. Loose parts or damaged impeller. 1. See authorized service dealer.
Engine overheats 1. Engine oil level low. 1. Fill crankcase with proper oil.
2. Dirty air cleaner. 2. Clean or replace air cleaner.
3. Carburetor not adjusted properly. 3. See authorized service dealer.
Occasionalskip (hesitates) 1. Spark plug gap too close. 1. Adjust gap to .030".
at high speed
Unit does not discharge 1. Discharge chute clogged. 1.
Rate of discharge slows
considerably or
composition of discharged
material changes.
2. Foreign object lodged in impeller.
3. Lowengine RPM
4. Vacuum bag is full.
1. Lowengine RPM.
2. Chipper blade dull.
Stop engine immediately and
disconnect spark plug wire. Clean flail
screen and inside of discharge opening.
2. Stop engine and disconnect spark plug
wire. Remove lodged object.
3. Always run engine at full throttle.
4. Empty bag.
1. Always run engine at full throttle.
2. Replace chipper blade or see your
authorized service dealer.
NOTE: For repairs beyond the minor adjustments listed above, contact your nearest authorized service dealer,
13

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Troy-Bilt CSV206 and is the answer not in the manual?

Troy-Bilt CSV206 Specifications

General IconGeneral
BrandTroy-Bilt
ModelCSV206
CategoryChipper
LanguageEnglish

Related product manuals