2, Beforestartingthemachine,makesurethechipper
chute,feedintake, and cutting chamber are empty and
free of all debris,
3, Thoroughly inspect all material to be shredded and
remove any metal, rocks, bottles, cans, or other foreign
objects which could cause personal injuryor damage to
the machine.
4, If the impeller strikes a foreign object or and/or ifyour
machine should make an unusual noise or vibration, shut
the engine off immediately. Allow the impeller to stop;
disconnect the spark plug wire, ground it against the
engine and perform the following steps:
a. Inspect for damage,
b, Repair or replace any damaged parts,
c, Check for any loose parts and tighten to assure
continued safe operation.
4, Do not allow an accumulation of processed material to
build up in the discharge area, This can prevent proper
discharge and result in kickback of material through the
feed opening,
5, Do not attempt to shred or chip material larger than
specified on the machine or inthis manual, Personal
injury or machine damage could result,
6, Never attempt to unclog either the feed intake or
discharge opening while the engine isrunning, Shut the
engine off, wait until all moving parts have stopped,
disconnect the spark plug wire and ground itagainst the
engine before clearing debris.
7, Never operate without vacuum bag and discharge chute
properly attached to the machine, Never empty or
change vacuum bag while the engine is running,
Zippered end of vacuum bag must be kept closed at all
times during operation.
8, Never operate without either the inlet nozzle or optional
hose attachment properly attached to the machine.
Never attempt to attach or change either attachment
while the engine isrunning,
9, Keep all guards, deflectors and safety devices in place
and operating properly,
10, Keep your face and body back and to the side of the
chipper chute while feeding material into the machine to
avoid accidental kickback injuries.
11, Never operate this machine without good visibility or
light. Always be sure of your footing and keep a firm hold
on the handles.
12. Do not operate this machine on a gravel surface.
13, Do not operate this machine while under the influence of
alcohol or drugs,
14, Muffler and engine become hot and can cause a burn, Do
not touch.
15, Never pick up or carry machine while the engine is
running,
Maintenance& Storage
1, Never tamper with safety devices, Check their proper
operation regularly,
2, Check bolts and screws for proper tightness at frequent
intervals to keep the machine in safe working condition,
Also, visually inspect machine for any damage and
repair, ifneeded,
3, Before cleaning, repairing, or inspecting, stop the engine
and make certain the impeller and all moving parts have
stopped. Disconnect the spark plug wire and ground it
against the engine to prevent unintended starting,
4, Do not change the engine governor settings or
overspeed the engine, The governor controls the
maximum safe operating speed of the engine,
5, Maintain or replace safety and instruction labels, as
necessary.
6, Follow this manual for safe loading, unloading,
transporting, and storage of this machine,
7, Never store the machine or fuel container inside where
there is an open flame, spark or pilot light such as a water
heater, furnace, clothes dryer, etc,
8, Always refer to the operator's manual for proper
instructions on off-season storage,
9, Ifthe fuel tank has to be drained, do this outdoors,
10, Observe proper disposal laws and regulations for gas,
oil, etc, to protect the environment,
YourResponsibility
Restrict the use of this power machine to persons who
read, understand and follow the warnings and
instructions in this manual and on the machine.
NOTE: Not all safety labels shown may apply to your
chipper shredder vacuum.
TO AVOD _ER_OUS 1_4J_RY
To Next Page
Loading...
Need help?
General
