14
CAUSE ACTION
Unit is unplugged Check cord to make sure it is still plugged into an electrical outlet
MOTOR WILL NOT START
TROUBLESHOOTING
CAUSE ACTION
Cutting attachment bound with grass Stop the unit and clean cutting attachment
Cutting attachment out of line Refill with new line
Inner reel bound up Replace the inner reel
Cutting head dirty Clean inner reel and outer spool
Line welded Disassemble, remove the welded section and rewind
Line twisted when refilled Disassemble and rewind the line
Not enough line is exposed Push the bump knob and pull out line until 4 inches (102 mm) of line
is outside of the cutting attachment
CUTTING ATTACHMENT WILL NOT ADVANCE LINE
CAUSE ACTION
Oil, cleaner or lubricant in cutting head Clean and thoroughly dry the cutting head
CUTTING LINE ADVANCES UNCONTROLLABLY
If further assistance is required, contact your authorized service dealer.
To Next Page
Loading...
Need help?
General
