TSC MB340 Series User Manual

- 23 -
3.4.3 Loading Media in Peel-off Mode (Option)
1. Open the printer right side cover.
2. Please refer to section 3.4.1 for loading
media.
3. Using the front display panel to do the
calibration first and set the printer mode to
peeler mode.
Note:
1. Please calibrate the gap/black mark
sensor before loading media in the
peel-off mode to avoid the paper jam.
2. Please feed the label through media
guide bar as picture shown.
4. Open print head release lever, pull
approximately 650 mm of the label through
the front of the printer.
5. Remove several labels to leave liner.
Label
Liner

TSC MB340 Series Specifications

General

Brand	TSC
Model	MB340 Series
Category	Printer
Language	English