3.3.4 Loading the Media in Peel-off Mode (TE210/TE310 Series only, dealer option)
1. Refer to chapter 3.3.1 to install the
label. Use “Diagnostic Tool” to set
the media sensor type and
calibrate the selected sensor.
2. Open the printer top cover by
pressing the top cover open tabs
located on each side of the printer.
3. Push the print head release button
to open the print head mechanism
and feed the media through the
media sensor. Move the media
guides to fit the label width.
4. Pull the label through the front of
the printer and take some labels off
only leave the liner.
To Next Page
Loading...
Need help?
General
