TSC TTP-342 Pro Series User Manual

32
4.1.3 Printer Initialization
Printer initialization clears all downloaded files resident in flash memory, and sets
printer parameters to default values.
Parameter
Default Value
Speed
200 dpi: 50.8 mm/sec (2 ips)
300 dpi: 38.1 mm/sec (1.5 ips)
Density
8
Label Width
4"(101.6 mm)
Label Height
4"(101.6 mm)
Sensor Type
Gap sensor
Gap Setting
0.12” (3.0 mm)
Print Direction
0
Reference Point
0,0 (upper left corner)
Offset
0
Tear Mode
On
Peel off Mode
Off
Cutter Mode
Off
Serial Port Settings
9600 bps, none parity, 8 data bits, 1 stop bit
Code Page
850
Country Code
001
Clear Flash Memory
Yes
Please follow the steps below to initialize the printer:
1. Turn off the printer power.
2. Hold down the PAUSE and FEED buttons and turn on the printer power.
3. Do not release the buttons until the three LEDs flash in turn.
Note 1: Printing method (thermal transfer or thermal direct printing) will be
set automatically at the activation of printer power.
Note 2: When printer initialization is done, please calibrate the gap sensor
again.
Note 3: Download files will be deleted after printer initialization.

TSC TTP-342 Pro Series Specifications

General

Brand	TSC
Model	TTP-342 Pro Series
Category	Barcode Reader
Language	English