10 Operating QUESTempº 48N
Print
4. For the Language setting, once selected, press I/O Enter key. To select a language,
press Up/Down Arrow keys. Once selected, press Run/Stop key to return to setup
parameters.
5. For the Log Rate, once selected, press I/O Enter key.
Repeatedly press I/O Enter keys to select either the Log Rate Event or a Log Rate
interval (for data logging; e.g. “5”).
Optional: changing Next Event field. Events are numbered starting at 1 and
incrementing. The number may be increased to simulate skipping events. This may
be useful if the events represent locations and the starting location is somewhere
other than 1.
Example of setting Log Rate to
Event Log
Next event number
*To increase, press up arrow key
(used to simulate skipping an event.)
Log Rate: event
Nxt event: 11
Figure 1-13: Selecting log rate with event log
6. For the Index setting, once selected press I/O Enter key. Press Up/Down Arrow keys to
select: “---” (which is equivalent for no index), ACGIH, PHEL, or Flag.
7. Exit Setup by pressing the Run/Stop key.
Print
Allows printing to a parallel or serial printer or to a computer. The QUESTempº 48N Heat
Stress Monitor will recognize the cable plugged in and configure itself for serial or parallel. If
no cable is plugged in, it will default to serial. Press I/O Enter key to begin printing. Press
Run/Stop key to return to the menu.
NOTE: If you want to stop the printing, press I/O Enter key until you return to the main
menu. When the printer has stopped printing, remove the cable from the printer to
the instrument.
Reset
Resetting enables you to clear the logged data from memory. Press the I/O Enter key to enter
the Reset mode. Clear the memory by holding down the I/O Enter key while the display
counts down from three.
To Next Page
Loading...
Need help?
General
