Ubee Interactive — www.ubeeinteractive.com
3 Ubee DDW36C – Safety and Installation Product Insert v1.0
phase-to-phase voltage at 100-120V.
8. Disconnecting the Device: If the device
becomes damaged or encounters some other
abnormality, disconnect the power plug from
the AC wall outlet immediately.
9. The device should be installed in a location
not to exceed the maximum temperature of
40 degrees Celsius (104 degrees
Fahrenheit).
10. When this device is placed upright with the
aid of the stand, the stand must be fixed at a
90-degree angle to the device. Otherwise, the
device will have the risk of tipping over.
11. Keep the device away from Children and
Pets.
12. Place the device on a cool surface. Failure to
do so may result in overheating which can
cause extreme damage.
13. Do not modify or attempt to disassemble the
device. Use it only according to the
instructions.
14. Do not dispose of the device in a trash
container. Please recycle.
Installation
To install this device, follow the procedures
below and refer to the following page for a
connection diagram.
1. Connect one end of a coaxial cable (not
included) to the CABLE port on the device.
To Next Page
Loading...
Need help?
General
