Ubee DDW36C Manual

Ubee Interactive — www.ubeeinteractive.com
4 Ubee DDW36C – Safety and Installation Product Insert v1.0
Connect the other end to a cable splitter or the
cable wall outlet. Be sure not to bend or over
tighten the cables as this may strain the
connector and cause damage. If you plan to
connect the device and a television to the
same cable wall outlet, you must use a cable
line splitter (not included).
2. Connect one end of the supplied Ethernet
cable to one of the ETHERNET ports (ETH1
to ETH4) on the device. Connect the other
end to the ETHERNET port on a PC. Note:
Category 5e or Category 6 Ethernet cables
with RJ-45 connectors must be used when
connecting Ethernet devices to the LAN ports.
This ensures Gigabit Ethernet speeds (unless
the computer does not support it).
3. Connect the power cord to the POWER port
on the device. Plug the other end of the power
cord into the AC wall outlet. Important: Use
only the power cord that is shipped with the
device.
Additional Information
1. RESET Button (back of device): This button
resets the device to factory defaults. Using a
pointed object, insert it into the button opening,
and hold for more than 10 seconds. The
device will reset and reboot. Note: Not all

Ubee DDW36C Specifications

General

Brand	Ubee
Model	DDW36C
Category	Gateway
Language	English