3
SPECIFICATIONS
INSTALLATION INSTRUCTIONS
This convection heater is intended for permanent wall-mounting with the provided
brackets.
The heater has a thermal cut-off protection. If the thermal cut-off protection trips,
switch off the power. The unit should reset automatically after 10 minutes. If the
thermal cut-off protection trips again, determine the reason for overheating.
Model
68125105
ECH104-B-750
68125106
ECH104-B-1000
68125107
ECH104-B-1500
68125111
ECH104-B-2000
240 V AC 240 V AC 240 V AC 240 V AC
Width
Depth
17.52” (44.5 cm) 17.52” (44.5 cm) 17.52” (44.5 cm) 17.52” (44.5 cm)
18.7” (47.5 cm) 22.64” (57.5 cm) 28.54” (72.5 cm) 34.84” (88.5 cm)
5.12” (13 cm) 5.12” (13 cm) 5.12” (13 cm) 5.12” (13 cm)
Tools required (not included)
• Electric drill
• Phillips (cross-head) screwdriver
• Tape measure
Do not install heater closer than 6" (15.3 cm) from to
a vertical or horizontal surface. This minimum
distance must be maintained. (Fig.1)
Fig.1
• Installation must be performed in accordance with the requirements of CEC by
authorized personnel only.