UNI-T UT61E User Manual

Warning
T
o avoid harm to yourself, do not input higher than DC 60V or AC 30V voltages.
To measure temperature, connect the Meter as follows:
1. Set the rotary switch to
.
2. Insert the temperature probe into the input terminal as shown on the figure 9.
3. Place the temperature probe to the object being measured.
After few seconds, the measured value shows on the display.
4. Press BLUE button to toggle between
and temperature.
Note
l
To avoid measurement error especially low temperature measurement, the
operating temperature must not exceed 18 ~ 28
.
l
When temperature measurement has been completed, disconnect the connection
between the temperature probe and the object being measured, and remove the
temperature probe away from the input terminals of the Meter.
Model UT61A/61B/61C/61D/61E: OPERATING MANUAL
34

UNI-T UT61E Specifications

General

Brand	UNI-T
Model	UT61E
Category	Multimeter
Language	English