UNI-T UTD2000CEX-II Series User Manual

Internal: Center of the screen
± 15 grids External: ± 6V
Automatic, normal, single
100ns~10s
1.23MHz
680kHz
Reduce Noise Waveform
(10 mV/div～20 V/div, DC coupling
trigger sensitivity reduced by 2 times）
≤1div
Trigger
Trigger Level Range
Trigger Mode
Trigger Holdoff Range
High Frequency Suppression
Low Frequency Suppression
Noise Suppression
Trigger Sensitivity
Edge Trigger
Edge Type
Rising, falling, any
Pulse Width Trigger
Pulse Condition
Polarity
Pulse Width Range
>、<、><
>、<、><
Positive, negative pulse width
20ns ~ 10s
Under-range Pulse Trigger
Pulse Condition
Polarity
Pulse Width Range
Positive, negative
20ns~10s
Voltage between cursors（△V）
Time between cursors（△T）
Frequency（Hz）（1/△T）
Voltage and time at waveform point
Allows auto display of cursor
Manual
Trace Mode
Indicator
Cursor
Supports NTSC, PAL，rows range is 1~525
(NTSC) and 1~625 (PAL/SECAM)
Video Trigger
Signal System
Frequency
Range
Measure
Positive slope (greater than, less than, specified range)
Negative slope (greater than, less than, specified range)
20ns~10s
Slope Condition
Time Setup
Slope Trigger
Beyond-range Pulse Trigger
Beyond-range
type
Trigger
Position
Beyond-range
time
Rising, falling, any
Entering, exiting, time
20ns~10s
UTD2000CEX-II User Manual

UNI-T UTD2000CEX-II Series Specifications

General

Brand	UNI-T
Model	UTD2000CEX-II Series
Category	Test Equipment
Language	English