-7- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
1.4 Getting Started
Scanner Turn on : Long press the trigger key for 2 seconds until you hear a
long beep sound.
Scanner Turn off : Long press the trigger key for about 7 seconds until you
hear a short beep sound.
￭ How to pair the scanner with the cradle
1. Firstly, select the interface you want to communicate with your PC, for
USB/RS232 cable connection, please switch the interface switch to the
left/right side as below figure and then connect the cradle and the PC via
the interface cable.
2. Long press trigger key for 2 seconds to turn on the scanner. And then put
the scanner on the cradle to start the BT pairing automatically.
3. When the pairing is completed, both the scanner LED and the cradle
LED will show solid blue light.
To Next Page
Loading...
Need help?
General
