www.urcsupport.com
14
CHECKING THE CODES
If you have set up the Polaris Remote Control by
searching for your device code (on the previous page),
you may need to find out which four-digit code is
operating your equipment. T
o find out which code is
operating your TV
:
1. On the remote control, press TV once; it blinks
once. Then press and hold SETUP until the TV
key blinks twice.
2. Enter 9 9 0. The TV key blinks twice.
3. To view the code for the first digit, press 1
once. Count the number of times the TV key
blinks (e.g., 3 blinks = 3) and write down the
number in the leftmost TV Code box on
page 13.
NOTE: If a code digit is 0, the selected mode key does
not blink.
4. Repeat step 3 three more times for the
remaining digits. Use 2 for the second digit, 3
for the third digit, and 4 for the fourth digit.
Finish writing down the code in the TV Code
boxes on page 13.
StarChoicePolaris Remote Rev 1 FRA.fm Page 14 Monday, January 8, 2007 4:57 PM
To Next Page
Loading...
Need help?
General
