Universal Electronics Polaris User Manual

www.urcsupport.com
9
Key Charts
Key Function
Use SETUP for all programming
sequences.
Quickly press SETUP twice to enable
backlighting of all the keys on your
Polaris Remote Control. After
backlighting has been enabled, quickly
press SETUP twice to disable
backlighting.
To turn on your television or satellite
receiver, press TV or SAT once.
Each device key has an embedded LED
(red light) that blinks upon selection
and indicates the remote control is
working and (after programming) is
sending signals. When backlighting is
enabled, all the keys on your remote
control are lit when you press any key.
Press GUIDE to display the program
guide.
Press OPTIONS once to display the
Options menu.
Press INFO to display the current
channel and program information.
In Guide mode, press DAY+ (or DAY-) to
move a day forward (or back) on your
satellite receiver’s program guide
(applies only to receivers with picture in
guide).
Press the navigator keys to move the
cursor in the program guide and menu
screens and to navigate within the
interactive service.
Press OK/SELECT to select the
highlighted program in Guide mode or
Menu option.
Press PAGE+ (or PAGE-) to page up (or
page down) through menu screens and
the program guide.
Press EXIT to exit out of your satellite
receiver’s menu and guide.
StarChoicePolaris Remote Rev 1 FRA.fm Page 9 Monday, January 8, 2007 4:57 PM

Universal Electronics Polaris Specifications

General

Brand	Universal Electronics
Model	Polaris
Category	Remote Control
Language	English