EasyManuals Logo
Home>Univex>Kitchen Appliances>VS2000

Univex VS2000 Instruction Manual

Univex VS2000
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
VS2000
Before mounting the VS9 to power source equipment, make sure the front housing [Fig. 2 (8)] is
securely latched to the rear housing [Fig. 2 (9), (10), (11)].
The thumb screw [Fig. 1(22)] should be firmly snugged immediately after mounting the VS9 to
secure the VS9 in place. Do not operate the VS9 if there is no
securing device present on the
power takeoff hub.
.
Never hose down a VS9 mounted to power source equipment. Hosing down a mounted VS9
invites electrical shock.
CIRCUIT BREAKER.
Ef the circuit breaker HAS TRIPPED, turn the power switch to "OFF," and disconnect the electrical
supply, determine and then correct the fault before resetting. To prevent unauthorized use, remove
the
;witch key.
Be sure the attachment is properly cleaned, assembled, and installed, tighten thumb screw
before
connecting to power source. Do not attempt to service the drive assembly. Please contact Univex Corp.
for the number of the nearest authorized service agent in your area.
OPERATION INSTRUCTIONS
The VS2000 should be setup in an area that is convenient for operation, and has
sufficient clearance
for safety. Before installing the VS9 attachment, make sure the PTO adapter [Fig. 1 (24)]
is properly
installed on the drive shaft. The vegetable slicer should be attached with a twisting motion
and in an
upright position. Make sure to tighten the thumb screw. When processing foods please observe
zperating and safety instructions. When processing is completed, turn power to "OFF" and disconnect
power source. Remove the attachment, disassemble, clean, dry and
sanitize before storing in a clean,
dry environment.
CAUTION
The VS2000 should not be used for any of the applications listed below. Failure to observe
these
guidelines may result in damage to VS2000 and will void the manufacturer's warranty.
Do not use the VS2000 to drive a meat grinder accessory.
Do not use the VS2000 to process hard cheese with the grater plate or any other plate.
Do not use the VS2000 to process soft cheese
PLATE ASSEMBLY
CAUTION: Again, wear hand protection when workìng with these units.
ADJUSTABLE SLICER PLATE ASSEMBLY [Figure 3J
To assemble the slicer plate, see Figure 3 and Diagram 5 component assembly order and
fit as shown.
The plate, when assembled, can be adjusted to slice product to different thickness by
turning the
"adjusting nut" per the directions accompanying Diagram 5.
WARNING:
Adjustments for thickness must never be attempted while the VS9 is under power or
;evere personal injury can occur. See safety precautions -
Paragraph 2.
SHREDDER PLATE ASSEMBLY [Figure 4J
To fit the plate of your choice to the hub and shaft [Figure 4], line up the key hole
slots on the plate
with the locating pins on the hub as shown below. Slip the plate over the pins and secure
it by turning
the plate in a clockwise direction until it shoulders up firmly on the pins. This can be
done most safely
by resting the plate face down on a butcher's block and turning the hub home from
above.
Page 3
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor

Other manuals for Univex VS2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Univex VS2000 and is the answer not in the manual?

Univex VS2000 Specifications

General IconGeneral
BrandUnivex
ModelVS2000
CategoryKitchen Appliances
LanguageEnglish

Related product manuals