OPERATING INSTRUCTIONS
The VS2000 vegetable slicer/shredder should be set on a level, stable surface and in an area that is
convenient for the operator with sufficient clearance around the unit for safe operation.
Before installing the VS9 attachment, make sure the PTO adapter is properly installed on the drive
shaft.
Inset the VS9 in the PTO hub with a twisting motion and in an upright position and tighten the thumb
screw.
When processing foods, please observe the operating and safety instructions.
When processing is completed, place the on/off switch in the “OFF” position, remove the key and
disconnect the power supply cord.
Remove the attachment, disassemble, clean, dry and sanitize it before storing it in a dry environment.
Never hose rinse the machine.
THUMB SCREW
PTO ADAPTER
ALIGNMENT PIN
LOCATING HOLE
PTO HUB
COVER CAP
POWER TAKE-OFF HUB (PTO)
FIGURE 2
Page 6
To Next Page
Loading...
Need help?
General
