1. If you feel that the brakes are too tight, please
use the M5 hexagonal wrench to loosen the plate screws
on the disc brake, slide the brake cable back so that the
length is slightly shorter, and then tighten the plate
screws; If you feel that the brakes are too loose, please
use the M5 hexagonal wrench to loosen the plate screws
on the disc brake, slide the brake cable back so that the
length is slightly longer, and then tighten the plate
screws; If you feel that the brakes are too tight, please
use the M5 hexagonal wrench to loosen the plate screws
on the disc brake, slide the brake cable back so that the
length is slightly longer, and then tighten the plate
screws.
2. If the stem of the scooter shakes, please use the
M5 hexagonal wrench to lock the two screws of the
folding mechanism.
3. 3. Before adjustment, make sure that the scooter
is stable and secure to prevent it from tipping over.
To Next Page
Loading...
Need help?
General
