area. Standard wiring schematics are also included at
the back of this manual.
Note to Electrical Inspector: Inspection of
electrical connection should be accomplished by the
removal of the lower finishing piece. This is done by
loosening the four screws located in the door opening
under the doors.
E.
OVEN ASSEMBLY
Before assembling and installing the oven, please
check to make sure that all necessary parts are
present. In addition to the oven itself, there will also
be four legs, four feet or four casters, the vent guard,
(for double sections: retaining clips & vent riser) and
miscellaneous hardware. Please check the interior of
all oven sections for the parts needed to assemble and
install the oven(s).
Leg Attachment
Once the oven has been removed from the
carton, lay it on its left side (the side without the
controls).
hold the leg and align with the threaded hole in the
front corner of the bottom of the oven.Carefully start
the bolt in the corner (avoid crossthreading).
Align the other two leg plate holes in the leg with
Those in the oven bottom and secure each leg using
the remaining two leg bolts. Repeat this process
for all legs.
Raise the oven up on the legs.
Level the oven by turning the adjustable feet in or
out as needed.
Caster Installation
Casters are available as an option for both the
single and double oven sections.
The installation of casters requires the removal of
the adjustable feet from the legs. This is done by
placing the bit of a large screwdriver against the lip
of the foot and rapping the screwdriver to drive the
foot out of the leg. The caster is then inserted fully
into the opening where the foot came out and the
locking nut tightened to expand the compression
sleeve of the caster.
NOTE:The casters with locking brakes are best mounted
on the front side of the oven for easieraccess.
NOTE: If you plan to use casters, a fixed restraint of the
Proper length must be incorporated to secure the oven to
a non-movable surface to eliminate strain on the power
cord.If the oven is removed from its normal position,the
restraint must then be reattached when returned.
Double Sections
Secure the short legs to the bottom of the lower
section as described in previous section.
Casters are installed by the method described
for single section ovens in the previous section.
Place upper section on top of lower section and
align all edges of the ovens.
Locate securing clips and align with holes on
rear frames of oven section, install three screws
each as provided and tighten.
At the rear of the oven, install the flue
connector by sliding it up through the flue vent
opening in the top of the oven and over the
upper flue vent. Push it flush with the back of
the oven then slide it down over the lower flue
vent. Attach with screws provided.
Install flue guard or draft hood adapter and draft
hood and draft hood collar to upper section.
F.
ADJUSTMENTS ASSOCIATED WITH
INSTALLATION
Each oven section and all its component parts have
been tested thoroughly and inspected before the oven
was shipped from the factory.However,it is
sometimes necessary to further test or adjust the oven
once it has been installed.Such adjustments are the
responsibility of the Dealer or Installer. These types of
adjustments are not considered defects,rather a
normal and routine part of the proper installation of the
equipment.
These adjustments include but are not limited to:
Adjustments and recalibration of the thermostat
Adjustment to the doors.
Leveling.
Tightening of fasteners.
WARNIN No installation should be
considered complete without proper inspection
and, if necessary, any adjustments by qualified
service or installation personnel.
To Next Page
Loading...
Need help?
General