Utax P-4530DN User Manual

2-5
Preparation before Use
14 Press [OK]. The DHCP setting is set and the IPv4 Setting menu
reappears.
Entering the IP address
If DHCP is set to Off, enter the IP Address manually.
15 Press  or  to select IP Address.
16 Press [OK]. The IP Address screen appears.
17 Use the numeric keys or  or  to set the IP address.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing  or .
Use  and  to move the position being entered, which is shown
highlighted.
18 Press [OK]. The IP address is stored and the IPv4 Setting menu
reappears.
Entering the Subnet Mask
When DHCP is set to Off, enter the Subnet Mask manually.
19 Press  or  to select Subnet Mask.
20 Press [OK]. The Subnet Mask screen appears.
21 Use the numeric keys or  or  to set the subnet mask.
You can set any value between 000 and 255.
The method for entering is the same as for the IP Address.
22 Press [OK]. The subnet mask setting is stored and the IPv4
Setting menu reappears.
Note DHCP becomes effective when On is selected. Press
[Menu] to end the mode selection menu.
When Off is set, continue on to enter the IP Address.
IPv4 Setting: a b
********************-
2 Auto-IP
3 IP Address
[ Exit ]
1 DHCP
IP Address: a b
/**0. 0. 0. 0
IPv4 Setting: a b
1 DHCP
2 Auto-IP
********************-
[ Exit ]
3 IP Address
Subnet Mask: a b
/**0. 0. 0. 0
IPv4 Setting: a b
********************-
5 Default Gateway
6 Bonjour
[ Exit ]
4 Subnet Mask

Utax P-4530DN Specifications

General

Brand	Utax
Model	P-4530DN
Category	Printer
Language	English