Utax P-C2660DN User Manual

Using the Operation Panel
4-44
IMPORTANT Depending on the paper used, printing in gloss mode
may cause wrinkle in paper. To reduce wrinkle, try using thicker pa-
per.
Use the procedure below to select Gloss mode. The default setting is
Low.
1 Press  while >Print Quality > is displayed.
2 Press  or  repeatedly until >>Gloss Mode appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select Low or High using  or .
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
EcoPrint Mode (Selecting the EcoPrint mode)
By enabling EcoPrint mode, you can minimize the amount of toner used
during printing. Because images printed in this mode may be slightly
coarser than those printed in standard resolution, you should use
EcoPrint for test prints or other situations where high-quality prints are not
required.
Use the procedure below to select EcoPrint mode. The default setting is
Off.
1 Press  while >Print Quality > is displayed.
2 Press  or  repeatedly until >>EcoPrint Mode appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using  or .
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
Page Set (Setting pagination)
In Page Set menus, you can set the number of copies, page orientation,
and other settings regarding pagination.
The options available in Page Set are as follows:
• Copies (Number of copies)
• Orientation (Print orientation)
• Wide A4 (Wide A4 pitch)
• XPS FitTo Page (Print area setting for XPS data)
• TIFF/JPEG Size (Print mode setting for TIFF/JPEG files)
1 Press  while Print Settings > is displayed.
2 Press  or  repeatedly until >Page Set > appears.
>>Gloss Mode
? Low
>>EcoPrint Mode
? Off
>Page Set >

Utax P-C2660DN Specifications

General

Brand	Utax
Model	P-C2660DN
Category	Printer
Language	English