Utax P-C2660DN User Manual

Using the Operation Panel
4-58
1 Once you have entered the correct ID in the previous step (ID
(Administrator ID input)), the message display shows
Password
(Administrator password input) and a blinking cursor (_).
2 Press  or  to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified password. Use  and  to move
the cursor right and left. Enter a password consisting of between 0 (no
settings) and 16 numbers.
3 Press [OK]. The Security screen appears.
TCP/IP (IPv4 settings)
This selects the settings for TCP/IP (IPv4). The method for setting is the
same as for the standard Network settings. For details, refer to TCP/IP
(IPv4 settings) on page 4-48.
TCP/IP (IPv6) (IPv6 settings)
This selects the settings for TCP/IP (IPv6). The method for setting is the
same as for the standard Network settings. For details, refer to TCP/IP
(IPv6) (IPv6 settings) on page 4-52.
Netware (NetWare setting)
NetWare is a PC-based network operating system specifically for servers.
NetWare is a client-server system that operates by installing the NetWare
OS on the server and dedicated client modules (NetWare clients) on the
client machines (running MS-DOS, OS/2, Windows, etc.). The basic
network layer protocol used is NetWare's own IPX (Internetwork Packet
eXchange)/SPX (Sequenced Packet eXchange), but the system also
supports TCP/IP.
The feature of the NetWare OS is that it is specifically for servers, unlike
general-purpose operating systems such as Windows NT and UNIX. Only
the minimum required for server operation can be performed from the
NetWare OS console on the server. Server and file management is
basically carried out using management tools from the clients. Also, all
drivers and protocol stacks are in the form of modules called NetWare
Loadable Modules (NLMs), and the ability of NLMs to load and unload
flexibly and dynamically is a major advantage of this system.
1 After entering the administrator ID and password, press  or 
repeatedly until >Netware appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Press  or  to select whether NetWare is enabled.
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
Password
_
Note If you enter the incorrect administrator ID or password,
the message Wrong ID or Wrong Password appears and
the input screen then reappears. Re-enter the ID or password
correctly.
>Netware
? On

Utax P-C2660DN Specifications

General

Brand	Utax
Model	P-C2660DN
Category	Printer
Language	English