3
HARDWARE CONTENTS
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING
●Consult a qualified electrician if you are not certain about the installation process.
PREPARATION
Before beginning to assemble or install lighting fixture, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is missing or damaged, do
not attempt to assemble the product.
Estimated Assembly Time: 5 - 10 minutes (Installation time will vary depending on skill level).
Tools required for Assembly (not included): Phillips screwdriver, Drill bit.
Important instructions before usage: Charge the battery fully before first use.
The solar panel must be installed facing the sunshine (typically on the roof) with maximum
sun exposure for a minimum of 4-6 hours a day.
Try to avoid areas of shade keeping in mind that obstacles will cast shadows at different times
during the day or seasons.
The light fixture should be installed on a flat and stable surface: the higher the installation the
larger the area of illumination.
Avoid installing the light near an air conditioner, heater, or high voltage system as quick
changes in temperature may cause the motion detection system to produce false triggers and
illuminate the light needlessly.
Avoid positioning the motion sensor head towards street traffic or anywhere other movements
may trigger the light needlessly and drain the battery prematurely.
Use a soft damp cloth to periodically clean the solar panel from accumulated dust or snow.
This will help preserve the life of the battery and maximize charging efficiency.
Helpful Items (not included): step ladder.
To Next Page
Loading...
Need help?
General
